Glass-fiber Premium

1. Pre-prepare the surface for gluing: fill cracks and potholes, primer the porous surfaces.
2. Measure a piece of glass-fiber on the height of the walls with a 5 cm margin for leveling.
3. Apply special glue to the prepared surface using a roller or brush.
4. Glue the measured piece of glass-fiber onto the wall surface vertically (along the slope).
5. Glue the next piece of glass-fiber butt.
6. Smooth glass-fiber with a spatula or a wide brush.
7. Cut glass-fiber along the edge of the wall with a knife and spatula.
8. Paint the glass-fiber no earlier than 24 hours after gluing.

IMPORTANT: when gluing glass-fiber, note that the front side is directed inside the roll.

Paint fiberglass is glued on smooth gypsum plaster or on a layer of starting putty by means of glue for wall-paper D 020 Elf ™. After gluing of a fiberglass it is necessary to carry out alignment with finishing putty D 60 Elf ™ or D 70 Elf ™ applied by a thin layer (a very thin layer). After applying the putty, it is recommended to cover the painting glass with a layer of UniGrund Elf ™ or GrundKonzentrat Elf ™. Upon completion of the above work, you can start decorating - painting, applying decorative plasters and coatings, and so on.