Metrics loading
High adhesion silicone primer paint for exterior and interior works
Need an advice?
facades, interiors
mineral fillers and polymer additives
250 g/m²
+ additional specifications

Ready-to-use silicone primer Silikon-PutzGrund 118 for preparation of bases before drawing silicone and silicate plaster finishing coverings ThermoELF.

  • Equalizes water absorption of a finishing basis and provides uniform hardening of a plaster covering
  • Recommended for the installation of thermal insulation systems using materials on silicone and silicate bases
  • Significantly improves the quality of formation of decorative textures such as "bark", "lamb", etc. 
  • To create a contact layer between the coating and the substrate
  • Recommended for conservation of thermal insulation systems
  • Capable of diffusion of water vapor
  • Resistant to precipitation
  • Recommended for toning
  • Environmentally friendly
Application technologies

The surface must be clean, dry, level, load-bearing and meet the conditions of preparation in accordance with the requirements.

Contaminants and substances that adversely affect adhesion must be removed and unevenness or chips smoothed with suitable materials, such as Klebe -und ArmierungsMasse AM 195 or KlebeMasse KM 193. The primed base has the appearance of a white rough surface.

Before use, Silikon-PutzGrund 118 primer must be thoroughly mixed with a low-speed drill with a special nozzle. If necessary, to adjust the consistency, the primer can be diluted with water, but not more than 5% by weight.

Primer Silikon-PutzGrund 118 must be applied with a paint roller, brush or paintbrush. After work or during long breaks, tools must be thoroughly cleaned and rinsed with water. During the work, the surface must be protected from precipitation, fog, strong wind or direct sunlight until the material is completely dry. Splashes and stains from primer on surfaces must be removed or washed off immediately with water. Silikon-PutzGrund 118 primer is not intended for the treatment of horizontal surfaces that are constantly exposed to water.

During application, and during drying, the ambient air temperature and the substrate must not fall below +5°C and rise above +30°C. Do not apply in direct sunlight, strong wind, fog, high humidity or when waiting for frost in the coming days.

Download materials (2)
Elf ™ Hygiene Certificate
Certificates – zip (14.56 MB)
Elf™ Catalogue
Catalogues – pdf (18.5 MB)

Where to buy

Click to show map
Get the address of your nearest dealer
If there is no showroom in your city, we will help you to buy our products from our dealers, in the most convenient place for you.