StrukturPutz Silicon

The surface must be clean, dry, level, able to bear the load and meet the preparation conditions in accordance with the requirements. Dirt and substances that have a negative effect on adhesion must be removed, and unevenness or chips should be leveled with suitable materials, for example "Klebe-undArmierungsMasse AM 195". Highly absorbent surfaces must be primed with materials such as the fixing primer "UniGrund" or the primer concentrate "GrundKonzentrat". Glossy surfaces such as concrete must be primed with "Silikon PutzGrund 118". In order to create a uniform optical effect and improve adhesion on the prepared base, it is recommended to use the primer "Silikon PutzGrund 118", tinted in the color of the plaster.

Preparation of material

"StrukturPutz Silikon" ready-to-use dispersion plaster. Mix the contents of the package thoroughly with a low-speed mixer. If necessary, to adjust the consistency, the plaster can be diluted with water, but not more than 2% of the mass. Adding water should be done in each bucket, in the same amount, to avoid differences in color and final decorative effect.

Attention!: you must always take into account the exact amount of water to adjust the consistency indicated on the package