The surface must be strong, clean, dry and suitable for processing. Carefully remove residues on the surface of old whitewashes made of adhesive-based or adhesive paints and varnishes. Smooth out irregularities with D 60 finishing putty. Treat the surface with Elf™ primer. Affected areas should be cleaned with special tools and treated with D 07 Fungicide primer according to the instructions.
Stir carefully before painting. Apply with a brush, roller or spray (including airless - "airless") in 2 layers.
1st layer - it is recommended to dilute the paint with up to 10% water.
2nd layer - it is recommended not to dilute the paint.
When applying by airless spraying, use a nozzle of 0.45-0.79 mm and a pressure of 160-180 bar. When applying by air spray, dilute with water to working viscosity and use a 2 mm nozzle. The drying time of each layer is 1-2 h at a temperature of +20°C and a relative humidity of 60%, in other conditions the drying time may change, with decreasing temperature it will increase. The application should be performed at a temperature not lower than +5°C and relative humidity not higher than 80%.